|
Charging FieldHawk is quite simple. Just connect the FieldHawk charger into a standard AC outlet, and connect FieldHawk to the charging jack. Operating Instructions- Connect the charger to a AC power source.
- You will see the LED flash green and red two times, then turn off. This means the charger is ready.
- Connect the FieldHawk radio to the charging jack. Please make sure that the power switch is turned off, and that you remove any 9v batteries from the kit.
- You will see the LED turn solid red which indicates that it is charging. Charging will normally take about two hours, but if you drained the batteries completely you should consider doing a longer charge of around 5 - 8 hours.
- Once the FieldHawk battery is fully charged you will see a solid green light. In this mode the charger switches to a trickle charge.
- You can now disconnect the charging jack from FieldHawk.
- Unplug the charger from the AC power source when not in use.
Important Notes - The charger is designed for indoor use only.
- Batteries during charging can explode or catch fire, never charge batteries unattended.
- The charger is designed for dry conditions.
- Don't cover the charger as it could cause it to overheat.
- Always charge batteries in a well ventilated area.
- Always charge batteries away from flammable liquids or materials.
- Never disassemble the charger for any reason.
- Never charge batteries for more than 12 hours at a time.
- Unplug the charger from the AC power source when not in use.
|
